| 50 Watt solar power system |
General description:
Shell Power System 50 Watt solar power system
for applications
with aprox. 3,15 Amp. Solar charge
requirement. Consisting of
1 piece
50 watt solar electric
module, regulator, cabling for installation and
battery.
|
|
Technical Specifications:
System contains the following components:
1 piece of: Single crystalline Solar modules of type
50 Wp. The solar module is designed to
meet or exceed the
environmental requirements.
Power rating 50 Watt
Solar charge controller:
Charge controller of type HEM212. The charge controller is a 12 Volt,
12 Amp solar charge and
12 Amp consume output, ensure overcharge and
low voltage protection.
The controller has the following performance:
- Solar module inputs. 12 Amp
- Load output: 12 Amp fuse.
- Protect against, low voltage discharge, battery overcharge and load
short-circuit.
Module structure:
1 piece of module support structure type UNI, for mounting of
1 module of type 50Wp
The structure is made of aluminum
capable of high withstanding wind speeds. Adjustable tilt angle.
The
structure is equipped with all necessary nuts and bolts of stainless
steel.
Battery:
Battery type: High quality, Gel 90Ah/12 Volt.
- 6 meters of cable 2x6 m2 for inter module cabling.
- Safe packing for transport of the equipment.
- Complete installation pack
Weight/Volume
- estimated weight: 37,41kg
Shipping details:
Gel batteries are approved for airfreight. However, due to weight,
sea-freight is recommended unless for emergency delivery/use.
Instructions for use:
Panel is mounted electrically to the aluminum support structure.
Panel
is installed on suitable and secure location with direct view of the
sun.
Support
Support structure elevation is adjusted for maximum (geographical
and day-round) solar power.
Cable run from panels to the charge regulator and from the charge
regulator to the battery,
and load from the charge regulator
The panels should be cleaned (water/soft brush) at regular
intervals to assure maximum effect.
print page |
|
|
